I Have Taken Vehicle To nissan Dealer On 3 Different Ocassions. Behind Me Was A Cargo Truck However At A More Gap Distance So That He Could Bring His Truck To A Halt Before Rear Bumping Me. She was able to start the car again after a few minutes and then was able to drive it home. Timing chains, tensioners, and guides replaced. Your Hazard Lamps will flash if you have performed this step successfully.
They Did Tell Me The Catalytic Gone Due To A Cylinder 2 Misfire But That Was Not Covered By Them. The manufacturer was notified and a report was taken. Drove To A Repair Shop To Get A Diagnostic Analysis On The Engine. Brake pads not worn, so rusted. Nissan had issued a recall, the car needed the ecm reprogrammed. Vehicle was not using Cruise Control.
Pressing On The Accelerator Did Not Do Anything. July 04, 2014 I Pulled Out Of A Parking Spot Onto A Busy Street When The Car Suddenly Shut Off While I Was Driving. The Contact Stated That The Check Engine Light Illuminated And The Vehicle Jerked Violently. Please Help Since This May Case Loss Of Life And Serious Accidents. Dec 20, 2013 Driving Down Highway And Motor Stopped In Fast Line Of Hwy 60 In Southeast Missouri And Almost Got Rearended By On Coming Traffic, Thank God They Stopped.
You Cant Get A Replacement Motor Anywhere Only Found One And They Want 2000. Finally the engine wouldn't start at all one day, so I had the car towed to the dealer, and they identified a problem with intake power valve screws that needed to be replaced at a significant price. When one headlight burned out, I decided to replace both headlamp assemblies. The oil warning indicators illuminated intermittently. My Steering And Brakes Got Locked.
An emmision valve was defective and was replaced. If you were moving at the time it would eventually come back on to the running position. The dealer stated that the computer needed reprogramming, and made the repair. Thank God It Would Turn Back On Right Away. The Vehicle Was Later Taken To A Private Mechanic Where It Was Determined That The Crankshaft Position Sensor Had Failed. Vehicle was not using Cruise Control. Was told I need a new radiator.
I took it back to the mechanic that had already replaced the sensor. The Vehicle Was Not Repaired. My wife was in shock. The Vehicle Was Taken To An Independent Mechanic. I Have A Family Of nissan Owners And This Was The First Incedent Of This Ever Happening.
Once Pulled Over To The Side, I Called My Insurance Co. . Vehicle was not using Cruise Control. Mar 28, 2014 The Contact Owns A 2003 nissan altima. Vehicle was not using Cruise Control. My Car Is No Longer Operable Because It Stalls So Violently, I Am Afraid I Will Crash And Put My Family In Danger.
The Vehicle Was Not Repaired. They said they tried to relearn the idle but it didn't take! The Contact Stated That While Driving 10 Mph, The Vehicle Stalled And The Check Engine Warning Light Illuminated After The Failure Occurred. Vehicle was not using Cruise Control. I noticed the steam, pulled over to examine the cause, and drove short distance to nearest shop. When the contact approached a stop, the vehicle shook, lost power, and would not restart quickly.